Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
B. Interlink the detectors
1. Activate the transmit mode of 1 detector by pressing the test button 4 times within 1 second. If this is
done correctly, the green LED will flash rapidly for 1 minute. Within this minute you can connect the
detector to other connectable Aroha Link detectors.
2. Press the test button of the other detector(s) twice within 1 second. This detector goes into
reception mode and the green LED light will flash slowly to confirm this. If pairing is successful, the
green LED light on the receiving detector(s) will stop flashing.
Optional: Upgrade your setup with an alarm notification on your phone by adding
a Aroha Smart Connect & Link Smoke Detector to your interlinked group. Shop now
on www.aroha.nl.
Frequently Asked Questions
Maximum interlinked detectors: 30 Aroha Link smoke, heat,
CO and combination detectors can be interlinked in 1 group.
Detector sounds an alarm: The test mode is activated as
the test button was not pressed fast enough. After the alarm
stops, try pressing the test button again 4 times as quickly
as possible within 1 second.
Connection fails: The green LED will continue to flash for 1
minute, followed by a red LED for 2 seconds to indicate that
the connection was not successful. In that case, start the
pairing process again.
Test detectors: The detectors have a transmission range of 100 meters without obstructions, such
as walls, ceilings, doors, and windows. After installation, you can test whether all detectors are
properly connected to each other by pressing the test button of 1 detector; then all test alarms
from all linked detectors will also sound.
85 dB alarm
Test/silence button
EN
LED light
04
Advertenties
Inhoudsopgave
