Inhoudsopgave
Advertenties
EN
Safety Notes
These Safety Notes include important information about installation, use, and maintenance of COLORband PiX M ILS.
■
ALWAYS:
♦
Connect to a grounded circuit.
♦
Connect to operating voltages as specified on the product's spec sticker.
♦
Disconnect from power before replacing the fuse.
♦
Disconnect from its power source during periods of inactivity.
♦
Use a safety cable when suspending overhead.
♦
Heed all restrictions and warnings on the spec sticker.
♦
Mount in a location with at least 20 in (50 cm) of ventilation.
♦
Replace the fuse with the same type and rating.
♦
Use a clamp with a captive bolt when a single hanging bracket is used.
■
In the event of a serious operating problem, stop using immediately.
■
DO NOT:
♦
Open this product or attempt any repairs. It contains no user-serviceable parts.
♦
Look at the light source when the product is on.
♦
Use if the power cord is crimped or damaged.
♦
Disconnect by pulling on the power cord.
♦
Allow flammable materials close to the product when it is operating.
♦
Touch the housing when it is on.
♦
Block any ventilation holes/slots in the housing.
♦
Connect to a dimmer or rheostat.
♦
Carry the product by its power cord.
♦
Operate in temperatures higher than 104°F (40°C).
♦
Expose to environments that exceed the Ingress Protection (IP) rating.
♦
Expose to rain or moisture.
♦
Use outdoors.
♦
Submerge.
♦
Leave outdoors for extended periods of time.
♦
Expose to corrosive environmental conditions such as temperature, humidity, salinity, pressure, radiation,
or shock.
♦
Set this product on a flammable surface.
FCC Compliance
This device complies with Part 15 Part B of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
What is Included
♦
COLORband PiX M ILS
♦
Power cable
Control Panel Description
Button
Function
<MENU>
Exits from the current menu or function
<UP>
Navigates upwards through the menu list and increases the numeric value when in a function
<DOWN>
Navigates downwards through the menu list and decreases the numeric value when in a function
<ENTER>
Enables the currently displayed menu or sets the currently selected value into the selected function
ILS Connection
The COLORband PiX M ILS uses the DMX data connection and the D-Fi USB for wireless connection to the Integrated
Lighting System (ILS) ecosystem (patent pending). For more information about configuring the COLORband PiX M ILS
into ILS mode, please refer to the User Manual available at www.chauvetdj.com.
1
QUICK REFERENCE GUIDE
♦
Hanging bracket
♦
Quick Reference Guide
COLORband PiX M ILS QRG Rev. 1
Advertenties
Inhoudsopgave
