Advertenties
Operation and maintenance
Remove all packaging of the device.
Check if the voltage of the appliance corresponds to the main voltage of your home.
Rated voltage : AC220-240V 50Hz, max. rated power 1500 Watt.
Place the device on a flat stable surface and ensure a minimum of 10 cm. free space around
the device. This device is not suitable for installation in a cabinet or for outside use.
Before first use
The four castor wheels (No. 7) have to be attached before the first use.
Turn the radiator upside down and rest on a soft surface to prevent scratching of the radiator
housing. Screw the wheel plates on to the radiator by using the wire loops
and wing nuts provided.
Place the pins of the castor wheels in the 4 holes of the metal
wheel plates and fix them with the nuts. Turn the radiator back to
its correct upright position.
Wheel plate
Castor wheel with nut
Some odour and fumes could occur resulting from the first use of your heater. It's normal for
the radiator to make a noise when it is being used for the first time.
Do not transfer your heater just after using it. Wait for a while so it can cool off.
Do not place the radiator just below a power socked. The radiator must not be used in a
bathroom or near a source of water. Never refill yourself the oil; it needs special oil. Only
approved agents are obliged to open up the oil container section to carry out repairs. Any oil
leak must be reported to an repaired by qualified service personnel.
Use
Select the desired position by switching the powerswitch (No. 4).
0
OFF
I
600W
Low power
II
900W
Medium power
III
1500W
High power
With the thermostat switch (No.3), the temperature can be regulated. When the desired
temperature is reached, the unit automatically switch off. Once the temperature has fallen
below the pre-set level, the heater will switch on again. The control light (No. 2) will allow you
to check the thermostatic regulation. When the appliance is heating, the control light will be on.
It will go out when the desired temperature is reached.
Attention! when using the device on places with a low amperage of the electrical network,
such as a camping you can only use position I (low power).
Do not cover the heater with any anything, like clothes.
Never use the heater in the bathroom or other wet area's.
9
Cleaning
UK
Always switch off the device and disconnect the power cord before cleaning. Let the heater
cool down completely. Clean your heater with a soft damp cloth. Do not use chemical materials
for the cleaning of your heater. Do not use dry and powder cleaners/detergents when cleaning
your heater. Never immerse it in water or other liquid. Never clean your heater by pouring
water on it, make sure that the heater is dry before using it.
Use the cord storage (No. 6) to wind the electrical wire for
storage of the device.
10
Advertenties
