Inhoudsopgave
Advertenties
16.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and damages
to the device.
16.2 Fault indications and rectification of faults
The following table assists in localizing and rectifying minor faults.
Fault
Device is not cold enough
The light does not work
Vibrations
The device seems to make too
much noise
The door will not close properly.
LED display does not show up
LED display error - Lo
► If you are unable to solve the problem with the steps shown above, please contact
customer service.
17 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety.
If these were put in the non-recyclable waste or were handled incorrectly, they
could be detrimental to human health and the environment. Therefore, do not put your old
device into the non-recyclable waste under any circumstances.
Please note
Possible Cause
Check the temperature control setting.
External environment may require a higher
setting. The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The device does not have the correct clearance.
The fan cover is dirty. Please clean the fan cover.
Please call the warranty service number
Check to ensure that the device is level
The device is not level. Also,please check the fan.
The device is not level.
The door is not properly installed.
The seal is weak. The shelves are out of position.
Main control board does not work.
PCB problem. There is a problem with the plug.
PCB problem, please contact customer service.
33
Advertenties
Inhoudsopgave
