Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
DEVICE DESCRIPTION
1.
Steam control slider and the function of
self-cleaning the iron from deposits
2.
Maximum water filling indicator
3.
Water sprayer button
4.
High steam impact button
5.
Temperature control knob:
6.
1.9 m rotating mains cable
BEFORE FIRST USE
1. Remove all stickers, covers and protective film from the iron's soleplate.
2. Wash and rinse the measure.
CAUTION! A smoke may come out of the iron during the first use. This phenomenon stops after
a short while.
PREPARATION FOR USE
FILLING THE WATER TANK
1. Make sure the device is not connected to the mains.
2. Set the steam control slider in (1) the "NO STEAM" position
3. Open the water filler cover (11).
4. Fill the water tank (8) to the maximum level using the measure. Check the maximum water
level by placing the iron in the vertical position.
CAUTION! Do not fill the tank over the MAX level. In order to get the best results, always use
fresh demineralized or distilled water. Do not use chemically descaled water or any other liquids.
5. Close the water filler cover (11).
USING THE DEVICE
TEMPERATURE SETTING
1. Connect the power cord plug (6) to a grounded power socket.
2. Place the iron in an upright position and set the required ironing temperature by turning the temperature
control knob (5) to the appropriate position. The indicator light (7) will illuminate to indicate heating.
MARKING ON THE IRON THERMOSTAT ADJUSTMENT
•
••
•••/max
CAUTION! Check the required ironing temperature marked on the tag. If you do not know the
fabric type of the ironed product, the correct ironing temperature should be determined by iron-
ing the part of the product that will be invisible when worn or used. We start from the lowest
temperature gradually increasing it . Silk, wool and man-made fabrics - to prevent the formation
of shiny stains, iron fabrics on the left side covering them with another thin fabric. Do not use
the sprayer function to prevent the formation of stains when ironing. Iron velvet and similar
7.
8.
9.
10. Sprayer hole
11. Water filler cover
12. Hand
13. Rear housing/base
low temperature
average temperature
high temperature
Operational status indicator light
Water tank with a capacity of 220 ml
Non-stick coated soleplate
.
FABRIC TYPE
synthetic materials
silk, wool
cotton, linen
EN
21
Advertenties
Inhoudsopgave
