Inhoudsopgave
Advertenties
Continuous dehumidifying
Press this button to let the dehumidifier run continuously for a maximum dehumidification until the water
reservoir is full. The buttons to set the air humidity cannot be used when the device is set to «continual».
Press this button again to cancel continual operation. You can also go back and use the buttons to set the
humidity.
The "Cont." indicator light will light up.
Smart dehumidifying
With this function the dehumidifier will check the humidity automatically and ensure a pleasant climate.
The level of humidity will be regulated between 45% and 55%. The level of humidity that was set with the
dehumidifying programme no longer applies.
The "SMD" (Smart Dehumidifying Mode) indicator light will light up.
3. Timer
TURBO
You can set the timer for a maximum of 24 hours. Pressing the "+" and "-" buttons will increase or
decrease the time by half an hour. With a setting of more than 10 hours, the time will increase or decrease
by an hour.
Timer for switching on automatically
Press the timer button while the appliance is off. The indicator light above the timer button will light up.
The display will show the time set. This can be increased or decreased with the "+" and "-" buttons. Once
the set time has passed, the appliance will switch on automatically.
Timer for switching off automatically
Press the timer button while the appliance is on. The indicator light above the timer button will light up.
The display will show the time set. This can be increased or decreased with the "+" and "-" buttons.
Once the set time has passed, the appliance will switch off automatically.
4. Fan
TURBO
Select the fan speed using the fan button. The appliance will reduce the humidity more quickly with a
higher ventilation speed. The indicator light above the button will light up:
·
Low: low speed
·
Med: medium speed
·
Low & Med: high speed
5. "+" and "-" buttons
Use these buttons to set the desired humidity percentage. This can only be done in the Dehumidify mode.
See point 2. Mode.
6. Display
The standard setting for the display indicates the air humidity in the chamber to an accuracy of
approximately 5%. When you select the humidity yourself with the buttons provided, you will always see
the desired humidity percentage for which the machine will be set.
Error Messages:
AS= Humidity sensor error: Pull the plug from the outlet and plug it in again. If the error message repeats,
have the machine looked at.
www.domo-elektro.be
37
DO343DH
Advertenties
Inhoudsopgave
