Advertenties
WPS900F/WPS910
8.2
Learning the system
I
NOTE
You must carry out the learning procedure within 4 minutes of activating
the front sensors. Once these 4 minutes have elapsed, the front system
will stop sending an ID code.
The system communicates by radio contact. The control unit must be programmed
to ensure it recognises the codes from the other devices.
See fig. g
Start the programming procedure as follows:
➤ Connect the voltage supply for the front control electronics.
➤ Switch on the ignition.
➤ Release the handbrake.
➤ Engage the reverse gear.
➤ Press the left and right button on the control unit simultaneously for 5 seconds.
✓ The loudspeaker will emit two tones and the red and yellow LEDs will light up
twice.
➤ Let go of the two buttons.
➤ Wait for a high-pitched tone and for the yellow LED to light up.
➤ WPS910 only: Wait for a low-pitched tone and for the red LED to light up.
➤ Wait for the loudspeaker to emit three tones and for the yellow and red LED to
light up three times.
➤ Switch the ignition off.
EN
Setting the system
15
Advertenties
