Inhoudsopgave
Advertenties
Device operation
NOTE! The monitor and camera are paired by default. No re-pairing
is necessary.
1. Connect the plug of the power cord to the camera and the other
end to the power supply. Connect the power supply to the power
outlet (fig. 2). The device will beep.
2. Press and hold the switch (11, fig. C) for 3-5 seconds to turn the
monitor on. After about 10 seconds, the camera image will be
displayed on the monitor.
3. Place the camera in a convenient location and point it in the
direction you want to monitor.
NOTE
Do not place the camera or wires in the baby's crib or within reach of the
baby (min. 1 meter distance) due to the risk of injuring or suffocating the
baby. In the event of image or sound interference, place the devices in
a different location and make sure they are not near other electrical devices.
Adding a camera
It is possible to pair a total of 4 cameras.
1. Press the back button (2, fig. C) to enter the main menu.
2. Select the "Cameras" option, then select the channel to which the
new camera is to be added (fig. 3a) and press the OK button. The
camera was paired with the monitor (fig. 3b).
3. If you have problems adding a camera, make sure the camera is
connected to a power source. If so, reset the camera by pressing
the reset button (5, fig. B), then add the camera manually (see:
Adding a Camera) and make sure the camera and monitor are
within 2 meters of each other.
Feeding time alarm settings
1. In the main menu, select the "Feeding" option (fig. 4).
2. Select the time after which the alarm should be triggered (A, fig. 4).
Select whether the alarm is to be triggered once or in a loop (B, fig. 4).
‑ 23 ‑
EN
Advertenties
Inhoudsopgave
