Inhoudsopgave
Advertenties
Note
•
When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
7
Place the water tray back into the
appliance (fig n).
8
Place the water tank back into the
appliance (fig r).
Cleaning the pre-filter
Note
•
If the pre-filter is damaged, worn or
broken, do not use. Visit
www.philips.com/support or
contact the Consumer Care Center
in your country.
Filter alert light
Follow this
status
F0 displays on the
Clean the pre-
screen and wick&
pre-filter cleaning
filter
alert
goes on
1
Pull the top part of the back panel
towards you to release it from the
appliance (fig c).
2
To remove the pre-filter, press the
two clips down and pull the filter
towards you (fig d).
3
Wash the pre-filter under a running
tap. If the pre-filter is very dirty, use
a soft brush to brush away the dust
(fig ‡).
4
Air dry the pre-filter.
14
EN
All manuals and user guides at all-guides.com
5
6
Descaling the
NanoCloud rotary
humidification wick
1
2
3
4
Note
•
Make sure that the pre-filter is
completely dry. If it is still wet,
bacteria may multiply in it and
shorten the lifetime of the pre-filter.
After the pre-filter is completely dry,
place it back into the back panel
(fig h).
Touch and hold
for 3 seconds to
reset the pre-filter cleaning time.
Filter alert light
Follow this
status
Descale the
F0 displays on the
NanoCloud
screen and wick&
rotary
pre-filter cleaning
humidification
alert
goes on
wick
Pull out the water tank (fig j).
Lift the water tray upwards and pull
it out horizontally (fig k).
Take the wick wheel off the wick
support (fig †).
Soak the NanoCloud rotary
humidification wick in cleansing
agent (e.g diluted white vinegar,
Citric acid solution) for two hours
(fig ˆ).
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
