Inhoudsopgave
Advertenties
Soliris io
1] Switch on the power supply.
2] Press the PROG button on the Somfy io control point paired with
the motorised product for about 2 s until the motorised product
completes an up-and-down movement.
3] Briefly press the PROG button on Soliris io.
The motorised product performs another up-and-down
movement.
The Soliris io sensor is paired.
͉
If several motorised products are paired to the control point, the up-and-down movement may take 2 minutes:
wait for the LED to stop flashing to confirm the pairing was successful.
To pair the Soliris io sensor with other io motors or receivers, repeat this procedure.
To pair using an io-homecontrol® control point from a partner brand or a Somfy io bi-directional control
point, please refer to the relevant guide.
2.5.2. Checking Soliris io pairing
1] Position the motorised product at the lower end limit.
2] Turn the Wind potentiometer (M) to the Demo position.
The motorised product moves up and down briefly.
3] Turn the anemometer (F) manually to simulate the wind blowing.
The motorised product automatically moves to safety position
after 2 s.
The Soliris io sensor is paired with this io motor or receiver.
Attention
Never leave the Wind potentiometer set to Demo.
2.5.3. Setting the wind sensitivity threshold
Table of thresholds
͉
In addition to the value in km/h and the number of flashes indicating the level set, the corresponding value on
the Beaufort scale is given for information purposes.
Thresholds
km/h
Number of flashes
Beaufort
equivalent
Copyright
2019-2022 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
©
1
2
28
38
★
★ ★
Bf 5
Bf 6
1]
2]
3]
1]
2]
3]
3
4
49
61
★ ★ ★
★ ★ ★ ★
Bf 7
Bf 8
ON
PROG.
PROG.
5
6
74
88
★ ★ ★ ★ ★
★ ★ ★ ★ ★ ★
Bf 9
Bf 10
EN
21
Advertenties
Hoofdstukken
Inhoudsopgave
