Inhoudsopgave
Advertenties
REMOVING AND REPLACING THE BLADE SET
To remove the blades, first unplug the clipper from the electrical outlet. Turn the
clipper upside down so that the blade teeth are pointing down. You may want to
place the clipper on a flat surface to do this. Unscrew the screws on the blades.
Remove the blades.
To replace the blades, put the smaller, upper blade back into position (Figure F). Line
up the screw holes in the bottom blade with the two holes in the clipper housing, and
replace the screws. Do not tighten down the screws completely. Turn the clipper over
and align the lower blade so the teeth on both blades are parallel, but with the lower
blade's teeth slightly above the upper blade's teeth. Failure to do this may result in
nipping the skin when cutting the hair.
BLADE & CLIPPER/TRIMMER REPAIR SERVICE
When the blades of your Andis clipper become dull after repeated use, it is advised
to purchase a new set of blades available through your Andis supplier or through an
Andis authorized service station. If you have a problem contacting your Andis
supplier contact the Andis Company customer service department at
1-262-884-2600 or email at info@andisco.com.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
CAUTION: Never handle your Andis clipper while you are operating a water
faucet and never hold your clipper under a water faucet or in water. There is
danger of electrical shock and damage to your clipper. ANDIS COMPANY will not
be responsible in case of injury due to this carelessness.
7
Advertenties
Inhoudsopgave
