Inhoudsopgave
Advertenties
7.4 Fuction hood controls
Timer symbol
After selecting the suction hood Digit, press the Timer Management Digit to set the
countdown.
Grease 昀椀lter maintenance symbol
The grease 昀椀lter cleaning signal is displayed by LED
Charcoal 昀椀lter maintenance symbol
• The hood is set by default to ducting mode. Press the On/O昀昀 key. With no loads
on, press the Hood controls digit to enable the suction hood. Press and hold the
Digit again for 5 seconds to:
Activate the charcoal 昀椀lter:
• The charcoal (anti-odour) 昀椀lter symbol lights up for 1 second and the device emits
a double beep.
Deactivate the charcoal 昀椀lter:
• The charcoal (anti-odour) 昀椀lter symbol 昀氀ashes twice and the device emits a double
beep.
Filter reset and reactivation
• After 200 hours of operation of the charcoal 昀椀lter and 100 hours of the grease
昀椀lter, the coming on of the relative icons will signal that it is necessary to perform
maintenance on the indicated 昀椀lter.
Having completed maintenance on the 昀椀lter with the hob o昀昀, proceed as follows:
• Turn the hob On/O昀昀
• Press the Hood digit
• Press key "A" for at least 5 seconds and wait for con昀椀rmation of the reset which
will be signalled by two beeps and the symbol disappearing.
• If the reset con昀椀rmation (double beep and symbol disappearing) does not occur
within 6 seconds, turn o昀昀 the hob and repeat the procedure from the beginning.
Press " 9 " on the power bar to set INTENSIVE 1 speed. This setting is timed to
"9"
operate for 10 minutes. Once this time has passed, the system will automatically
return to the speed set previously. It is deactivated by selecting a di昀昀erent speed.
Press " 9 " on the power bar twice to set INTENSIVE 2 speed. This setting is timed
to operate for 5 minutes. Once this time has passed, the system will automatically
return to the speed set previously. It is deactivated by selecting a di昀昀erent speed.
This function is only available if Automatic mode is deactivated. Automatic mode is
deactivated by pressing
Delay
Press the suction hood Digit and set a speed on the power bar.
Press the Timer management Digit, which was displaying "CL" but will change to the
countdown. This is pre-set to 15 minutes.
to activate the numbered bar.
.
and it is always enabled.
15
Advertenties
Inhoudsopgave
