Download Inhoudsopgave Inhoud Print deze pagina

Charging Your Cleaner; Surface Cleaning; Adjusting Clearance Height - Water Tech Pool Blaster LEAF VAC RECHARGE Gebruikershandleiding

Inhoudsopgave

Advertenties

English
Only use the battery charger supplied with the cleaner.
Specifications
Battery charger Input.........................................................................100-240V-50-60Hz, 0.3A Maximum
Battery charger Output.......................................................................................................12.6V,
Battery Technical Data................................................................11.1V, 2200mAh, 24.42Wh, 3S1P Li-Ion
Water temperature range................................................... Maximum 96°F, (35°C) Minimum 40°F, (5°C)
Operation Depth.......................................................... Maximum 12 ft. (3.5 m), Minimum 10 in. (0.25 m)
Charge temperature.................................................... Maximum 100°F, (37.7°C) Minimum 50°F, (10°C)
SETTING UP THE POOL BLASTER LEAF VAC RECHARGE
A

Charging Your Cleaner

Initial Charge 4 Hours
Recharging (After Complete Discharge) 4 Hours
Maximum charging time should not exceed 24 Hours
B
Closing Charging Port
C
Securing Pole Adapter
SURFACE CLEANING AND ADJUSTING CLEARANCE HEIGHT
G

Surface Cleaning

Push the pole adapter down until the adapter locks in place. Turn the cleaner "ON." The Leaf Vac may now be used in the
"Wheels Up" position to skim leaves and other floating debris from the pool's surface.
H

Adjusting Clearance Height

The Leaf Vac is packaged with its clearance height in the "LOW" position. The height of the Leaf Vac can be raised up to 1/4
inch if needed by doing the following: H.1 - Use a small screwdriver or pair of needle-nose pliers to remove the "E"-clip from
the top of the wheel pivot shaft. H.2 - Remove the wheel pivot shaft assembly. Don't lose the "E" - clip and spacer.
H.3 - Place the spacer on the pivot shaft and guide the shaft back into the body from beneath. H.4 - Replace the "E"-clip on
the top of the shaft.
Repeat these procedures on the remaining 2 wheel pivot assemblies.
MAINTENANCE AND LONG TERM STORAGE
Cleaning the Filter Bag
• You should remove and clean the Filter Bag following each use.
• Clean out the debris bag following each use and carefully remove any debris that might be stuck in the propeller area of the cleaner.
• Don't scrub the bag against itself while rinsing it.
Long Term Storage
• Always clean the Unit and Filter Bag before storing.
• Always store and charge your cleaner in a cool, dry indoor shelter.
• Recharge the cleaner indoors for 4 hours after each month of inactivity.
• Never leave your charger connected to the cleaner for more than 24 hours.
1
2
1.A
D
Attaching Filter Bag
E
Inserting Pool Pole
F
Turning Unit ON/OFF
Note:
While cleaning, leaves may settle around the propeller reducing cleaning
effectiveness. Should this occur, just shake the Leaf Vac back and forth to
dislodge the settling leaves and continue cleaning.
3
4
5
P11AX022AP
(1) Filter Bag
(2) Pole Adapter
(3) Battery Chamber Cover
(4) Wheel Assembly
LC099-3S6SQ
(5) Charger and EU Adapter
(Not included)
6

Advertenties

Inhoudsopgave
loading

Inhoudsopgave