Inhoudsopgave
Advertenties
Cleaning, Care & Maintenance
Note: Always switch off and disconnect the appliance from the power supply
before cleaning.
•
Do not use any abrasive cleaning agents on the appliance. Use warm soapy water.
•
Do not immerse the motor housing in water. Clean the exterior with a damp cloth.
•
Always dry thoroughly after cleaning.
For ease of cleaning, disassemble the appliance:
•
Unscrew the barrel cap.
Note: If the cap has been put on too tight, knock the corners of the cap with a
rubber mallet or similar instrument to loosen it.
•
Remove the mincing barrel, plate, blade and feed screw as one unit. Gently tip the barrel to remove
the pieces one by one.
•
Twist off the hopper tray.
•
Remove meat from all components and wash in warm, soapy water.
•
Dry thoroughly.
•
Lubricate the parts with a little cooking oil before replacing for best performance.
Troubleshooting
A qualified technician should carry out repairs if required.
Fault
The unit is not working
Minced meat does not exit
the appliance evenly
CB943_ML_A5_v6_20220622.indb 5
CB943_ML_A5_v6_20220622.indb 5
Probable Cause
Unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
The barrel cap is on too
tight
The cutting plate is blocked
The cutting blade is blunt
Appliance is overfilled
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Loosen the cap
Remove and clean the plate
Replace the cutting blade
Follow instructions for clearing a jam
EN
5
2022/6/22 10:27
2022/6/22 10:27
Advertenties
Inhoudsopgave
