Inhoudsopgave
Advertenties
Cleaning, Care & Maintenance
•
Switch off and disconnect from the power supply before cleaning.
•
Clean the interior of the appliance as often as possible.
•
Soak the milk pipe and container in a soapy water for about 10 minutes then rinse thoroughly.
•
Do not use abrasive cleaning agents. These can leave harmful residues.
•
Clean the door seal with warm soapy water.
•
Always wipe dry all parts after cleaning.
•
If left unused for any length of time, store the appliance with the door ajar.
Cleaning the Condenser
•
The condenser is part of the refrigeration system. Clean the condenser monthly with a vacuum
cleaner or a brush.
•
Always disconnect power supply before carrying out Routine Maintenance.
•
Failure to clean the condenser will increase energy consumption, reduce the performance and life of
your Polar unit, and thus may invalidate your warranty.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not
The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Fridge cabinet is not
Temperature set incorrectly
cold enough
Condenser blocked with dust
Door is opened too often
Unit located near a heat source or air
flow to the condenser interrupted
Ambient temperature is too high
The appliance is
The appliance is not installed in a
unusually loud
level or stable position
PG005_ML_A5_v1_20240826.indb 5
PG005_ML_A5_v1_20240826.indb 5
Probable Cause
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Check temperature and reset if necessary
Consult a qualified Technician
Only open when necessary
Move the appliance to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Check installation position and change if
necessary
EN
AU
5
2024/8/26 15:58:30
2024/8/26 15:58:30
Advertenties
Inhoudsopgave
