Inhoudsopgave
Advertenties
4. Connect one end of a connection cable
EN
mask connector
5. Connect one end of the other connection cable to the
neck mask connector
6. Attach the hub to the charging port
The face mask and neck mask can be used separately.
In this case, directly connect the mask to the controller
with a connection cable.
7
Operation
WARNING! RISK OF INJURY!
• Do not use the product for more than
10 minutes per session.
Clean all parts of the product before first use as
described in the chapter "Cleaning".
7.1 Preparation
1. Fully charge the product and properly attach the elastic
straps (see chapter "Charging" and "Assembly").
2. Thoroughly clean and dry your face and neck. Make sure
they are free from any make-up or dirt.
3. Sit or lie down and place the masks over your face and neck.
4. Use the hook-and-loop fasteners on the ends of the
elastic straps to fit the face mask
comfortably on your face and neck.
The small elastic straps
your head and the large elastic straps
at the back of your head. The medium elastic straps
should be closed at the back of your neck.
7.2 Carrying out the session
1. Press and hold the operation button ( )
the product.
The operation lights
switched on. By default, the product goes into mode "M1"
at energy level 1.
The corresponding mode indicator light
The current energy level briefly shows in the numeric
display
time.
11
and the other end to the hub
3
15
before changing to show the remaining operating
11
and the other end to the hub.
4
16
and neck mask
1
should be closed at the top of
5
illuminate when the product is
to the face
8
.
17
of the controller
2
should be closed
6
7
to switch on
13
illuminates.
12
.
9
Advertenties
Hoofdstukken
Inhoudsopgave
