4. INSTALLATION INSTRUCTIONS
Before using your thermoelectric cooler
▪
Remove the inner and outer packaging.
▪
Allow the appliance to rest for two hours before switching it on.
▪
Clean the inside using a soft cloth and lukewarm water.
Installing your appliance
▪
The appliance is only designed to be free standing, and must not be recessed or built-in.
▪
Position it in a place with sufficient strength to support its weight when loaded. To ensure that
it is level, adjust the height of the feet underneath.
▪
To get the best from your appliance with the lowest energy consumption, do not place the
appliance close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and
do not place it in a room which is too cold.
▪
Connect the appliance to a single socket, leaving a sufficient gap between the back of it and
the wall as well as on each side. Be careful to support it, so that it is perfectly level. (Use of a
spirit level is recommended). This will prevent any movement due to instability, causing noise
and vibration, and will ensure that the door seals perfectly.
5. USE INSTRUCTIONS
It is recommended that you installed the thermoelectric cellar in a place where the ambient
temperature is around 25°C. If the ambient temperature is above or below recommended
temperatures, the performance of the unit may be affected. For example, placing in extreme cold or
hot conditions may cause interior temperature to fluctuate. The range of 11-18°C may not be reached.
The temperature may fluctuate depending on whether or not the interior light is on or off or whether
the products are located on the upper, middle or lower section.
Temperature adjustment
▪
Press the
or
▪
Press the
key to turn on and off the interior light.
NOTE :
▪
This product is designed for maximum cooling of 15°C below ambient temperature.
▪
When the ambient temperature around 25°C or less, unit can maintain a temperature range
between 11-18°C.
All manuals and user guides at all-guides.com
keys to increase or decrease the temperature by 1°C.
17