Inhoudsopgave
Advertenties
The Venom 2 control unit uses Bluetooth 5.0 wireless technology with the
following radio specifications:
FCC ID: 2AWQY-VENOM2, IC: 26929-VENOM2, Frequency: 2402 to 2480 MHz
This unit complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This control unit may not cause harmful interference, and (2) this
control unit must accept any interference received, including interference that may
cause undesired operation. This control unit complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions: (1) this
control unit may not cause interference, and (2) this control unit must accept any
interference, including interference that may cause undesired operation of the unit.
This equipment complies with FCC/ISED radiation exposure limits set forth for
an uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines and RSS-102 of the ISED radio frequency (RF) Exposure rules. This
equipment has very low levels of RF energy that are deemed to comply without
testing of specific absorption rate (SAR).
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le onctionnement.
Advertenties
Inhoudsopgave
