Advertenties
Thank you for buying this product. Our company is
sure that you will be more than satisfied with the
product's performance.
Carefully read the "INSTRUCTION BOOKLET" which
is supplied together with this product, since they
provide important information regarding the safety,
installation, use and maintenance of the product.
This product complies with recognised technical
standards and safety regulations. We declare that
this product is in conformity with the following
European Directives: 2004/108/EEC.
This is a type C device according to EN 12453-5.5.1.
It can also be used as a presence detector, hence
as a type D device according to EN 12453. For both
purposes, it will only be in conformity with directive
2006/42/EEC provided it is connected to a control
panel from the same manufacturer equipped with a
test circuit that looks for faults in the safety circuits
and with a conforming safety edge.
WARNING:
- when carrying out connection and installation
operations always refer to the current legislation
in force, as well as to good technical principles.
- making changes to the device or to the unit's
configuration without consulting the manufac-
turer may result in hazardous situations.
USING THE DEVICE
Keep areas that lead to the safety device clear of
obstacles. More specifically, make sure that no
branches or shrubs break the beam emitted by
the transmitter. If the safety device is triggered, no
resetting or re-enabling is required since the gate's
regular operation will be restored automatically.
MAINTENANCE AND SCRAPPING
ERIS A30 RX features a battery low warning LED
LD6. When LD6 starts flashing, it means ERIS A30 TX
has about one month's battery life left: replace the
battery. When the device is connected to a control
panel from the same manufacturer, provided with a
fault-finding circuit in safety circuits, it requires no
maintenance, since testing is carried out automati-
cally with each manoeuvre (test intervals conforming
to risk analysis or EN12453). In the case where the
fault-finding circuit in safety circuits is not used, get
qualified personnel to check the device function at
intervals not longer than 6 months. The materials
making up the appliance and its packing must be
disposed of according to current regulations.
In case of malfunction, request the assistance of
qualified personnel.
All adjustments, whether mechanical or electrical,
must be carried out by authorized personnel only
in accordance with the safety rules and instructions
issued by the manufacturer. You are advised to check
at regular intervals:
- that the safety edge is not damaged or permanently
misshapen; otherwise, have it replaced by qualified
personnel;
- that the battery low warning LED (LD6) is not
flashing; refer to table 2) and the previous section
for replacement instructions;
- that the device features legible markings;
8 - ERIS A30
www.metalines.com
OPERATING AND INSTALLATION INSTRUCTIONS
If excessive amounts of dirt build up on the surface
of the photocell, clean the photocell lenses with a
cloth.
SCRAPPING Materials must be disposed
of in accordance with the regulations in
force. Do not throw away your discarded
equipment or used batteries with household
waste. You are responsible for taking all your
waste electrical and electronic equipment to
a suitable recycling centre.
WARNING!
Correct operation is only ensured when the data
contained in the present manual are observed.
The company is not to be held responsible for
any damage resulting from failure to observe
the installation standards and the instructions
contained in the present manual.
The descriptions and illustrations contained in
the present manual are not binding. The Com-
pany reserves the right to make any alterations
deemed appropriate for the technical, manu-
facturing and commercial improvement of the
product, while leaving the essential product
features unchanged, at any time and without
undertaking to update the present publication.
The declaration of conformity can be viewed on
this website: www.bft.it in the product section.
sales@metalines.com
Advertenties
