Inhoudsopgave
Advertenties
The hair dryer has 4 temperature levels and 3 air flow speeds, selectable via separate
buttons. The appliance is also fitted with cold air button for hairstyling.
Switch the appliance on using the 0/1 switch [A].
Select the desired air speed using the [C] button:
= delicate air flow
= mid air flow
= strong air flow
Select the desired temperature using the [B] button:
= cold temperature
= low temperature
= mid temperature
= high temperature
Once you have identified the desired air/heat combination, lock the buttons by lifting
the [A] 0/1 switch to BLOC position ( ).
To change the air flow or heat, place the [A] 0/1 switch in position 1 again.
After use, using the 0/1 switch [A] switch off the appliance.
Do not pull the cord or the appliance to disconnect the power cord [G] from the
mains socket.
Store the appliance on a stable surface, paying attention not to wrap the cord
around the appliance.
COLD AIR BUTTON (COLD SHOT) [C]
The button can be used for hairstyling.
Holding the cold air button pressed, the dryer can be switched quickly to operate
with cold air and for hairstyling.
To return to the set temperature, simply release the button.
NEGATIVE ION ON/OFF BUTTON [K]
• Move the lever button to I to generate negative ions when using the hair dryer.
• Move the lever button to O to use the hair dryer without negative ion output.
USING THE AIR CONCENTRATOR NOZZLE [H]
Thanks to the nozzle, the air is conveyed directly on the brush used for the hairstyle.
Apply the concentrator and press it in towards the body of the hair dryer (Fig. 2a).
The concentrator can be retrieved by pulling it in the direction indicated by the arrow
b (Fig. 2b).
Wait until the nozzle has cooled down before removing it.
USING THE AIR DIFFUSER [I]
The diffuser can be used to obtain a volumising drying.
Apply the diffuser and press it in towards the body of the hair dryer (Fig. 3a).
The concentrator can be retrieved by pulling it in the direction indicated by the arrow
b (Fig. 3b).
MAINTENANCE
In case of malfunction or damage to the appliance or a part of it,
the appliance must be analysed by the manufacturer or the relevant
technical assistance or in any case by a person with similar skills in
order to prevent any risk. The user must not disassemble the device
him/herself.
Remove the plug from the mains socket before cleaning the ap-
pliance.
GENERAL CLEANING
Carry out a general cleaning of the device when the signal lamp [J] starts flashing or
at least once a week.
To avoid all risk of electric shock, do not clean the appliance with water and do not
dip It into water.
Only wipe the appliance with a soft cloth, dampened if necessary.
Do not use solvents or abrasive detergents!
FILTER CLEANING
IN ORDER TO MAINTAIN THE VALIDITY OF THE WARRANTY, THE
HAIR DRYER'S TRIPLE PROTECTION FILTER MUST BE KEPT CLEAN
AT ALL TIMES.
Follow these simple rules:
1. Remove dirt from the triple protection filter [E]. Use a soft-bristle brush.
9
Advertenties
Inhoudsopgave
