Inhoudsopgave
Advertenties
will flash red when you finish a brushing cycle or power off the
toothbrush.
2. Ensure the entire toothbrush is fully dry, paying particular
attention to the bristles and the area around the bottom of the
toothbrush.
3. Connect the USB-A connector of the Charging Base to a power
source, then place the toothbrush into place, ensuring the front
of brush is facing the same direction as the front of the Charging
Base (the side with the "ORDO" logo).
4. The battery indicator will light up red to show the toothbrush is
being charged.
5. Charge the toothbrush for 8 hours or until the charging light turns
off.
6. Switch off the power source and disconnect the Charging Base.
Troubleshooting
Problem
The toothbrush isn't
charging.
The toothbrush
operates with only
a small amount of
vibration.
The toothbrush
does not run for 2
minutes.
Safety Instructions
The toothbrush is designed exclusively for cleaning teeth. It is only
intended for private use and is not suitable for commercial purposes.
Only use the toothbrush as described in these operating instructions.
Any other use is deemed improper and may result in damage to
property or even personal injury. The toothbrush is not a child's toy.
Ordoclub Ltd accepts no liability for damage caused by improper or
incorrect use.
Risk of electric shock
A faulty electrical installation or excessive mains voltage may result
in an electric shock.
• Only connect the charging base if the mains voltage of the socket
corresponds to the specification on the nameplate.
• The main cord of the charging base cannot be replaced. In the
event of damage, the charging base must be disposed of.
• Only connect the charging base to an easily accessible socket
so that you can quickly disconnect it from the mains in case of a
failure.
6
Possible Cause
The charging base
may be defective.
The USB connector
may be defective.
The charging base
is defective.
The rechargeable
battery is depleted.
The rechargeable
battery is depleted.
WARNINGS & CAUTIONS
Solution
Try other sockets
or USB ports
and charge the
toothbrush for at
least 8 hours.
Replace the
charging base
within the warranty
period. Contact our
customer service
team.
Charge the
toothbrush for at
least 8 hours.
Charge the
toothbrush for at
least 8 hours and
make sure that
the toothbrush is
properly placed on
the charging base.
Advertenties
Inhoudsopgave
