Advertenties
SeeSnake
Figure 10 – Do Not Allow Cable to Uncoil Freely
Installing System Cable
If the system cable slip-ring module is not installed,
squarely insert the slip-ring module into the hub and twist
it clockwise until it locks into position. (See Figure 11.)
Slip Ring
Module
Cover
Figure 11 – Locking The Slip Ring Module Cover
Do NOT touch the contact pins in the slip-
ring module. This can cause the contact pins to break.
NOTI E
The contact pins will not break under normal use, cor-
rectly connected. However pressing sideways on them
can cause them to break, as shown in Figure 12.
Broken
Contact
Pin
Figure 12 – Broken Contact Pin
8
®
microReel Inspection System
Unlocked
Locked
Ridge Tool Company
Reversing/Installing The Display Cradle
(microEXPLORER Camera Monitor)
If you are using the microReel with the microEXPLORER
Camera monitor unit, you may find it more convenient to
have the microEXPLORER Camera monitor facing the
other way when it is seated in its cradle. To reverse the ori-
entation of the cradle, do the following:
1. Remove the microEXPLORER Camera monitor dis-
play from the cradle. With a Philips head screw-
driver, remove four screws holding the cord-wrap
arms and cradle to the case. Remove the cord-wrap
arms and the screws (Figure 13).
Cradle
Figure 13 – Cradle Support and Cord-Wrap Arms
2. Use one of the screws to remove the nuts from the
back side of the cradle. The nuts are friction-fitted into
the holes on the opposite side of the cradle from the
cord-wrap arms. By inserting a screw from the back
and threading it two or three turns into the nut, you
can pull the nut out.
3. Without taking the nut off the screw, insert the screw
and nut into the hole on the opposite side of the cra-
dle from which the screw was removed. Firmly seat
the screw into the friction-fit at the bottom of the
hole.
4. Unthread the screw. Repeat for each of the remaining
three nuts.
5. Position the cord-wrap arm and cradle on the rear of
the case, facing in the opposite direction. Make sure
the cord-wrap horns point outward.
6. Start each screw into its nut by hand. Tighten the
screws with the screwdriver.
7. Replace the display unit in the cradle.
Use a similar process for installing the display cradle.
Screwhead
Cord-Wrap
Arm
Advertenties
