Inhoudsopgave
Advertenties
SPECIFICATIONS
Voltage
No-load Speed
Cutting Mechanism
Cutting Line Type
Cutting Width
Recommended Operating
Temperature
Recommended Storage Temperature -20°C-70°C
Optimum Charging Temperature
Weight (without battery pack)
Measured sound power level L
WA
Sound pressure level at operator's
ear L
PA
Guaranteed sound power level L
(measured according to 2000/14/EC)
Front-assist
handle
Valuation of
vibration a
h:
Rear handle
◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used; In order to protect the operator, user should wear
gloves and ear protectors in the actual conditions of use.
PACKING LIST (FIG.A1)
DESCRIPTION
KNOW YOUR LINE TRIMMER (Fig. A1)
1. Socket
2. Lock-off Lever
3. Threshold Ring
4. Loop Handle
5. Trimmer Line
6. Guard Assembly
7. Shaft
8. Trigger
56 V
9. Rear Handle
Up to 5800 /min
10. Trimmer Head(Bump head)
Bump Head
11. Release Tab
2.4 mm nylon
12. Line-cutting Blade
twist line
13. Safety Barrier Bar (For brush cutter head only)
38 cm
14. Locking Pole For Safety Barrier Bar (For brush cutter
0°C-40°C
15. Out Flange (For brush cutter head only)
16. Nut (For brush cutter head only)
17. Screw
5°C-40°C
18. Allen key
5.8 kg
19. Nut
95 dB(A)
ASSEMBLY
K=1.1 dB(A)
82 dB(A)
K=2.5 dB(A)
do not operate this product until the parts are
replaced. Use of this product with damaged or missing
96 dB(A)
WA
parts could result in serious personal injury.
2.1 m/s
2
K=1,5 m/s
2
or create accessories not recommended for use with
1.8 m/s
2
this Line trimmer. Any such alteration or modification
K=1.5 m/s
2
is misuse and could result in a hazardous condition
leading to possible serious personal injury.
could cause serious personal injury, always unplug the
battery connector from the socket when assembling
parts.
cutter head, the safety barrier bar should be mounted.
MOUNTING THE GUARD
or replacing the guard. Take care of the blade on the
guard and protect your hand from cutting.
guard firmly in place. The guard must always be on
the tool to protect the user! When the guard is fixed,
never attempt to remove or adjust the guard, if a
replacement is needed, it should be performed by a
qualified service technician!
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — STX3800
head only)
WARNING: If any parts are damaged or missing,
WARNING: Do not attempt to modify this product
WARNING: To prevent accidental starting that
WARNING: When the tool is equipped with brush
WARNING: Always wear gloves when mounting
WARNING: Never operate the tool without the
EN
7
Advertenties
Inhoudsopgave
