Inhoudsopgave
Advertenties
V
ereenvoudigd EU-
Conformiteitsverklaring
Hierbij verklaar ik, INDEXA GmbH, dat het type radioapparatuur, FD25, conform is met Richtlijn
2014/53/EU. De volledige tekst van de EU-conformiteitsverklaring kan worden geraadpleegd
op het volgende internetadres:
http://www.pentatech.de/de/downloads/cat_view/13-ce-erklaerungen.html.
Recycling
Werp verpakkingsmateriaal en lege batterijen of defecte apparaten niet zomaar weg,
maar laat deze recyclen. Vraag uw gemeente naar het adres van het recyclingbedrijf in
uw buurt.
Introduction
Read through these operating instructions fully and carefully. The operating instructions belong
to this product and contain important points concerning bringing the appliance into service and
its operation.
Always pay attention to all safety instructions. Should you have any questions or be unsure about
operating the appliance - ask a specialist, inform yourself on the internet under
www.pentatech.de. Keep these instructions in a safe place and should the need arise pass them
on to a third party.
Proper use
This device consists of a motion detector with transmitter FD2B and a wireless chime with receiver
FD2G. The transmitter has a unique coding which is already enrolled to the receiver. The set can
be extended by additional transmitters (FD2B or doorbells FD2K) as well as wireless chimes
FD2G. The infrared motion detector reacts to the movement of persons within its detection range
and sends a wireless signal to the receiver. The receiver responds with a flashing light or with an
selectable chime sound.
The appliance is designed exclusively for indoor use in private households. The motion detector is
powered by two AA (LR6) batteries or by a USB mains adapter 5 V DC, min 100 mA. The wireless
chime is to be connected to a 230 V AC, 50 Hz mains outlet.
Any other use or change of the appliance is improper use. No liability shall be assumed for
consequential damage as well as damage which is caused by improper use or incorrect
operation.
This appliance is not intended to be used by people (including children) with restricted physical,
sensory or mental capacities, or a lack of experience and/or knowledge, unless they are
supervised by, or receive instructions how to use the appliance from, a person responsible for
their safety. Children must be supervised in order to ensure that they do not play with the
appliance.
Package contents
After unpacking, immediately check that the contents are complete and that the equipment is
undamaged.
1 Wireless chime
1 Support
1 Motion detector
2 Screws
Features and Equipment (see illustrations)
1 Wireless chime
6 Screw hole
2 LED
7 Motion detector
3 Chime selection button 8 Sensor lens
4 Volume button
9 LED
5 Support
10 Battery compartment cover 15 Battery compartment
Technical data
Motion detector FD2B:
Operating voltage:
3 V
DC
Current draw:
30 µA standby 5
(
Power supply:
2 x battery 1.5 V alkaline LR3 (AAA) or Micro USB adapter
5 V DC, min. 100 mA (all not supplied)
Detector:
passive infrarot (PIR) with fresnel lens
PIR detection range (horizontal): approx. 5 m x 95° (max. 20°C, see fig. E)
ca. 9 m x 40° (vertical, see fig. F)
Frequency band
433,05 - 434,79 MHz
Maximum radiated transmission power < 10 mW
Transmitter range:
approx. 70 m (outdoors)
Coding:
16 Bit precoded (>65,000 possible codes)
Operating temperature:
0 °C to +40 °C
Case dimensions:
approx. 85 x 54 x 35 mm
Weight:
approx. 60 g (without batteries)
Wireless chime FD2G:
Operating voltage:
230 V
AC, 50 Hz
Power consumption:
max. 0.1 W (standby), max. 0.5 W (operation)
Frequency band
433,05 - 434,79 MHz
Maximum radiated transmission power < 10 mW
Chime sounds:
24 chimes selectable
Chime sound level:
max. 82 dB(A) at 0.3 m (4 levels selectable)
Flashing light:
4 x LED
Operating temperature:
0 °C to +40 °C
Case dimensions:
approx. 80 x 87 x 28 mm (without plug)
Weight:
approx. 86 g
Safety instructions
Danger!
Life and health are endangered if the following instructions are not observed.
!
Do not leave small children unsupervised with the appliance, batteries, packing material or
small parts. Otherwise there is a risk of fatal injury due to choking
!
The mains power supply for the receiver and if applicable for the adapter for the transmitter
must be 230 V AC and fused according to local regulations.
!
Do not expose the appliance to moisture. Otherwise there is a danger to life or risk of injury.
!
Do not damage any gas pipes, or electricity or telecommunication cables when fixing.
Otherwise there is a danger to life or risk of injury or damage.
!
Make sure that the batteries are not short-circuited, nor thrown into fire. They must also not
be recharged or opened. There is a danger of fatal injury due to explosion.
!
Leaking or damaged batteries can cause burning upon contact with the skin. Where this is
the case use suitable protective gloves.
Attention!
Non-observance of the following instructions puts property at risk of damage.
!
Only operate the appliance with the approved types of batteries.
!
Avoid the appliance coming into contact with moisture.
!
If the equipment will not be used for a long time, remove the batteries.
GB
2 Wall plugs
11 On/Off switch
12 Connection for mains adapter
13 Fixation for support
14 Arrow marking
); 1 mA (operation)
Advertenties
Inhoudsopgave
