AC Power
This product has an auto-ranging power supply that works with an input voltage range of 100 to 240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
Power Linking
For the maximum number of EZLink Strip Q6BT products that you can power link at each voltage, see the User Manual or
the sticker on the product.
Fuse Replacement
1.
Disconnect the product from power.
2.
Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3.
Pry the safety cap out of the housing.
4.
Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the exact same
type and rating.
5.
Re-insert the fuse holder and reconnect power.
Battery Power
The EZLink Strip Q6BT comes with a rechargeable lithium battery for cable-free operation.
Charging the Battery
The battery charges whenever the EZLink Strip Q6BT is plugged into a power source using the included power cord. If
the product is plugged in and not in operation, make sure the product is turned off.
•
The LED indicator light will flash if you overpower your units.
•
DO NOT use the EZLink Strip Q6BT on full power mode (all LEDs at 100%) while it is being
charged/plugged into a power source, as the unit will get extremely hot.
Battery Life Indicator
The indicators on the LED Menu Display show how much battery life remains available. The drawing below provides a
key to reading the battery life indicators.
100%
Battery Run Time
Maximum Run Time (all colors on)
Up to 8 hours
EZLink Strip Q6BT QRG Rev. 6
QUICK REFERENCE GUIDE
75%
50%
25%
Recharge Time
7.5 hours
EN
2