Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Inserting the sealing
compound into the gun
For use with cartridges
1) Cut off the tip of nozzle at a point
suitable for the job. (Fig. 3)
2) Pull the rack all the way to rear. (Fig. 4)
3) Unscrew the tube holder from the
housing, and remove the sausage
pack adapter from the rack. (Fig. 5)
4) Install the tube holder on the housing,
remove the front cap from the tube
holder, and insert the cartridge. (Fig. 6)
5) Set the nozzle and install the front cap
on the tube holder. (Fig. 7)
6) Push the rack until touching the
cartridge. (Fig. 8)
For use with sausage pack
1) Cut off the tip of nozzle at a point
suitable for the job. (Fig. 3)
2) Pull the rack all the way to rear.
(Fig. 4)
3) Unscrew the tube holder from the
housing.
4) Screw sausage pack adapter on to
piston joint. (Fig. 9)
NOTE:
• Make sure that the plunger rotates
smoothly.
5) Install the tube holder on the housing,
remove the front cap from the tube
holder, and insert the sausage pack.
(Fig. 10)
6) Set the nozzle and install the front cap
on the tube holder. (Fig. 11)
7) Push the rack until touching the
sausage pack. (Fig. 12)
IV
. OPERATION
How to use the sealing
gun
1) Hold the grip while holding the tube
holder. (Fig. 13)
All manuals and user guides at all-guides.com
2) Set the nozzle in the groove, then
3) The tube holder can be rotated. This
4) Set rack speed according to work.
CAUTION:
• Be sure to lock the trigger ("0" position)
5) The rack will retract slightly when you
CAUTION:
• Dripping can occur with small nozzle
6) You can pull the trigger repeatedly to
For hard compounds
• Warm the sealing compounds until the
• Slow down the speed by selecting the
• Make the nozzle cut diameter bigger.
CAUTION:
• Make sure the front cap is tightened
• Do not touch the rack to avoid getting
• Use the tool only for its intended purpose,
- 12 -
squeeze the trigger (L). The rack will
move forward.
makes sealing application even easier
in hard-to-work places.
You can easily change speeds while
working by rotating application speed
control (K) by finger.
when finished working.
Speed rate adjustment
0
1 Slow
Lock
release the trigger, so as to prevent
dripping.
openings or exceptionally soft sealing
compounds.
dispense small shots of compound.
As long as you pull the trigger within
1 second of each shot, the rack will
move forward slowly without retracting.
compounds become soft.
application speed control.
(Fig. 14)
securely when working.
your fingers pinched.
and do not operate it for long periods of
time without interruption, since this may
damage the sealing gun or cause the
cartridge to jam. Do not insert a cartridge
if it is wet, or if the sealing compound has
hardened.
Fast 5
Advertenties
Inhoudsopgave
