Advertenties
Beschikbare talen
Beschikbare talen
3. PROPER USE
• Please note that this product is only intended for household use. Leifheit does not provide a manufacturer's
warranty for commercial use.
• Only use this device for cleaning wet, smooth surfaces, such as windows, mirrors and tiles.
• No dust may be sucked in.
• Do not use the window cleaner on rough surfaces so as to avoid damage to the rubber lip.
• The device is not suitable for suction of large quantities of fluids above 100 ml, flammable or sticky fluids.
• Only use this device in connection with conventional window cleaning agents (no spirits, no foam cleaner).
We recommend: Leifheit Glass Cleaning Liquid or Window Spray.
• Only use this device with the accessories and spare parts approved by Leifheit.
Any other use is considered to be improper. The manufacturer is not liable for damages resulting
from improper use. The user alone shall bear the risk for this
Rubber wiping blade
Suction nozzle
Dirty water tank
(removable)
Side tank valve
for draining
Figure 2: Window cleaner operating controls
4. START-UP / CHARGING THE BATTERIES
• The window cleaner is not delivered with a fully charged battery.
Therefore, please fully charge the battery prior to the first use.
• The battery reaches full capacity after some full charges and use cycles.
• Attach the suction nozzle to the tank. Push the two accompanying locking tabs
into the tank's upper surface until you hear the connection make an audible click.
The visible screws should be facing down in this position (see figure 3).
• Before you charge the device, please ensure that the device is switched off
(see figure 4).
• Connect the charger to the charging connector. Plug the charger into the socket.
The LED display will flash green while the charging.
The LED will be solid green once the battery is fully charged.
• The battery may only be charged by using the supplied charger.
• The charger is only to be used in connection with the Leifheit window cleaner.
• Always charge the rechargeable battery after work and always store the device
fully charged.
5. USE
1. Suction clean the surface
• Clean the window as usual with water and a cleaning agent. Switch the window
vacuum on by pushing the main power switch; the indicator light will be a steady
green. Place the rubber lip of the device on the surface to be vacuumed and use
light pressure to pull it from top to bottom across the surface. To achieve the best
results, hold the appliance at a 45° angle to the pane (see figure 5).
• Hard-to-reach surfaces can be suctioned either from top to bottom, sideways
or upside down. If a windowsill or very wide window frames prevent or hinder a
vacuuming to the bottom edge of the window pane, vacuum across the pane
once at the end of the vacuuming process.
IM_Fenstersauger_Dry&Clean_38min_01-2024.indd 45
IM_Fenstersauger_Dry&Clean_38min_01-2024.indd 45
Tank release button
Operation / battery charge display
Appliance switch (on / off)
Charging connector
Handle receptacle for all Leifheit Click System handles
Base
Figure 3:
Attaching the suction nozzle
Figure 4:
Appliance switch in the off position
45°
Figure 5:
Suction angle
45
GB
01.02.2024 07:11:11
01.02.2024 07:11:11
Advertenties
Hoofdstukken
