Advertenties
Beschikbare talen
Beschikbare talen
3.3
Safe operation
Only operate the SwimSkim CWS if no persons are in the water.
►
Do not operate defective units. Never operate the unit if either the cable or the housing is defective!
►
Pull the power plug immediately. Repairs to the connection cable are not possible as it is cast. In the
event of damage to the connection cable, do not operate the SwimSkim CWS. It has to be disposed
of in accordance with the regulations.
Install the SwimSkim CWS such that any risk of injury of persons is excluded.
►
Never open the housing or its attendant components, unless this is explicitly mentioned in these
►
instructions of use.
Only use original spare parts and accessories for the unit.
►
Never use the pump for fluids other than water.
►
Clean the filter basket at regular intervals.
►
4
Installation
Assesmbly of the SwimSkim CWS (Figure B, C)
1. Plug the handle (4) on the filter basket (8).
2. Fit the float switch (2):
Start by inserting the bottom engagement hook (9) in the opening of the pump chamber provided
−
for this purpose.
Then press the float switch down while swinging it against the pump chamber, until the upper
−
engagement hook (10) audibly engages.
3. Tighten the flow-out nozzle (3) at the pump on the underside of the pump chamber.
4. Align the flow-out nozzle (3) with the flat sealing ring (14) opposite to the skimmer flap (13).
The flow-out nozzle is correctly aligned when the arrows (11) on the underside of the unit and on
−
the flow-out nozzle point to one another.
Note: The blowback generated by the flow-out nozzle firmly holds the SwimSkim CWS at the
securing cord or at the securing cords (D) once fastened to the ground stakes.
5. Adjusting the flow-out nozzle (3).
With swirl-up function: Turn the valve (12) such that the water flows out downward to swirl up the
−
sludge from the bottom of the pond.
Without swirl-up function: Turn the valve (12) such that the water flows out sideways. The sludge
−
on the bottom of the pond is not swirled up.
6. Inserting the foam filter (7):
If necessary, the foam filter (7) can be used to filter out fine-grain soiling (e.g. pollen).
−
Installing the SwimSkim CWS (Figure D)
1. Place the SwimSkim CWS into the pond.
2. Fix the SwimSkim CWS in the pond:
Fasten at the pond edge: Fasten one securing cord each from the scope of delivery at the eyelets
−
of two float switches (2). Fix the securing cords at the pond edge using the ground stakes (6) such
that the SwimSkim CWS is in its desired position.
Fasten at the bottom of the pond: Fasten one securing cord each from the scope of delivery at the
−
two eyelets at the unit underside (1). Fix the securing cords to the bottom of the pond, e.g. using
rocks, such that the SwimSkim CWS is in its desired position.
Note: Only put the SwimSkim CWS into use when it is firmly fixed in the pond.
11876-07-13_GAW_SwimSkim CWS.pdf11 11
- GB -
11
01.08.2013 14:04:46
Advertenties
Hoofdstukken
