Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Diagram 2: Correct Wall / Ceiling Position
Diagram 3: Installation using a stand
The Colorado may be installed on an adjustable stand (Model M-Stand, available separately). Installation is
easy following the diagrams below.
CAUTION:
•
Ensure mains power is OFF before commencing installation.
•
The supplied mains cable must not contact the top surface of the heater during operation.
•
Heater must not be located immediately below a socket outlet. Electrical connections must be made
outside of the footprint of the unit to avoid heat build-up. If the heater is to be mounted on an incline
(e.g. sloping roof), ensure the electrical connection is located below the lowest end of the heater.
•
Joists, beams and rafters shall not be cut or notched to install the appliance.
•
This heater is not intended for ceiling-recessed installation. Do not install pointing directly downwards.
•
The identification mark and model reference should be visible after installation.
•
The COLORADO must not be attached facing or close to any combustible material (eg, wood or PVC
cladding, fascia or soffit) or other materials that could blow onto the heater.
•
The fixed wiring insulation coming into contact with parts with a temperature rise of greater than 50°C
must be protected, for example, by sleeving having an appropriate temperature rating.
•
Exercise caution when siting the heater stand that the heater cannot accidentally be touched, knocked-
over or that the wire causes a tripping hazard.
•
Never place the stand and heater next to a swimming pool, pond or other water source.
ENGLISH
Advertenties
Inhoudsopgave
