Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
English (ENG)
Bathtub Assembly Instructions
Manufacturer and importer:
Beliani GmbH, Haldenstrasse 5, 6340 Baar, Switzerland
Instruction for use
These instructions for use must be carefully read before installation.
Inspecting the goods upon delivery
Upon receipt, check the product for completeness and any damages. If any damage is evident,
inform the seller immediately. We shall not be liable for damages occurring during or after
installation.
Lifting/moving the tub
To lift or move the tub, grasp it by the edges - never by the hoses or installation parts.
Laying pipes
Pipes must not be laid beneath the bathtub.
Protection against damage
Utilise appropriate protective covers to prevent damage to surfaces and blockages caused by
dirt or dust during the fitting process. Before commencing the installation/fitting, temporarily
cover sensitive components such as drains, nozzles, and the control panel with protective
covers.
Special Precaution
When cleaning the tiles, ensure that ammonia or any similar aggressive cleaning agents do not
come into contact with the built-in components.
Electrical connection (230 V)
This task should only be undertaken by a qualified electrician. Ensure protection is provided
through a residual current circuit breaker (30 mA).
Safety regulations
During the installation of the bathtub, there are several simple steps to consider, preventing
potential accidents. The installation should only be carried out by qualified technicians. The
bathtub must be connected to a voltage of 230 V AC at 50 Hz. The device must be powered
through a residual current device with a rated residual current not exceeding 30 mA.
3
Advertenties
Inhoudsopgave
