Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Foil application
NOTE: When applying the foil, make sure that the
side to be welded is facing down.
IMPORTANT:
• Do not put the foil so that it faces the heating
plate with the layer intended for sealing! It may
stick the foil to the heating plate and contaminate
its surface!
• Use only rolls in which the winding of the film is
wound with a weldable layer inside the roll.
Attaching the roll of foil:
• Pull the roll support out of slot 1.
• Place the roll with foil 2 on the roll support 1 at
the back of the appliance.
• Slide the support with the roller back into the
slot.
• Manually unwind the beginning of the foil 3 and
Turning ON
To turn on the appliance please follow the steps
below:
• Ensure that the appliance is placed in a stable
place.
• Connect the power cable to socket 1 on the ap-
pliance, and then to the ~ 230V mains socket,
equipped with an efficient circuit of the protective
installation (grounded pin).
• Turn on the appliance by pressing the power
switch 2.
put it under the foil holder 4.
• Place the foil on the surface of the frame 5.
Turning on the appliance is indicated by the back-
light of switch.
IMPORTANT:
Before use, preheating is requiring. (6 to 10 min-
utes).
Thanks to the use of a programmable temperature
regulator, the temperature of the heating plate af-
ter heating will be automatically maintained at the
set level, which will ensure stable conditions for
the sealing process.
The appliance is equipped with a built-in safety foil
cutting system. The construction of the sealer pro-
tects the operator from burns or cuts.
• Set the temperature of the heating plate with the
sealing temperature controller.
EN
7
Advertenties
Inhoudsopgave
