Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
9. The "ADD WATER" indicator will light up when the water reservoir is lack of water and the
ice-making cycle will stop automatically. At that time, remove the ice basket and add water to
the water reservoir, and then press "ON/OFF" key again to restart the
ice-making cycle. The appliance will start working automatically after about 30 minutes if the
operator forgets to restart the appliance after refill.
10. When you have got your desired amount of ice, stop the ice making cycle by pressing the
"ON/OFF" key and unplug the unit from the wall outlet.
11. Open the top lid and transfer the ice to a freezer.
12. Allow the ice maker to reach room temperature.
13. Suggest replacing the water every a week. Please empty the water reservoir if the ice maker
is not used for a long time.
Cleaning and maintenance
1. Stop the ice-making cycle by pressing the "ON/OFF" key, unplug the ice maker from the wall
outlet and allow it to warm up to room temperature.
2. Tilt the whole unit for about 30°and move it forward to the place where the drain plug is about
60mm away from the countertop. Open the drain plug and drain the excess water (see Fig.1).
3. Remove the ice basket.
4. Clean the ice maker interior with a soft cloth soaked with warm water and vinegar, then rinse
with clean water and then drain all the water.
5. Replace the drain plug well in position. Wash the ice basket and ice scoop in warm soapy
water. Rinse and dry.
6. Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing soap, if
necessary.
NOTE: Do not use organic solvent, boiled water, detergent, strong acid and strong alkali
etc. for cleaning.
7. Please empty the water reservoir and dry it for storage if the ice maker is not used for a long
time.
8. Deep cleaning
Fill the ice cube maker with lukewarm water to the
MAX line and add a teaspoon of distilled white
vinegar. Select 'CLEAN' and then press the 'ON/OFF'
button to start the cleaning programme.
We recommend that you deep clean the Ice Cube
Maker once per week if using it on a daily basis.
When the programme starts, the 'CLEAN' display
will show constantly and it will start blinking once the
cleaning programme has been completed.
A cleaning process takes around 60-65 seconds and
the cycle will progress automatically (5 cycles).
When the cleaning programme is completed, empty
the water with the vinegar and then fill the beholder
up to the MAX line with clean water.
Run the 'CLEAN' programme again to flush out the
device.
To disinfect the machine, you can use
disinfectants made for ice cube makers
as long as they are PH neutral (level 6-7).
Follow the instructions on the bottle.
18
Drain plug
Drain plug
Fig. 1
Countertop
Drain plug
Advertenties
Hoofdstukken
Inhoudsopgave
