Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
This is a diagnostic charger. The LED will flash in a specific
order to indicate the battery's current status. (See figure).
Never leave the battery on the charger once it is fully charged and
ready to use.
4.3.1.2
Fault indication
When the battery is inserted in the charger and the LEDs flash red,
remove the battery from the charger for a minute and then insert again.
If the LEDs flash green, this means that the battery is
�
charging normally.
�
If the LEDs still flash red, remove the battery and unplug the
charger again.
Wait a minute, then plug the charger in again and reinsert the
battery. If the LEDs flash green, this means that the battery is
charging normally.
If the LEDs flash red, the battery is defective and must be
�
replaced.
4.3.2
Battery
4.3.2.1
Charge verification
If the battery does not charge correctly :
�
Check the socket using another device. Make sure that
power is reaching the socket.
�
Check that the contacts on the charger have not been
short-circuited by debris or foreign objects.
IF THE AMBIENT TEMPERATURE IS UNUSUAL, MOVE THE
CHARGER AND THE BATTERY TO SOMEWHERE WHERE
THE TEMPERATURE IS BETWEEN 7° AND 40 °C (45 AND
104 ºF).
iF THE BATTERY IS INSERTED IN THE CHARGER WHEN IT IS
WARM OR HOT, THE RED LEDs MAY COME ON. IF THIS
HAPPENS, ALLOW THE BATTERY TO COOL AWAY FROM
THE CHARGER. THE BATTERY MAY BE CHARGED
NORMALLY
TEMPERATURE IS ACHIEVED.
REFER TO THE CHARGER AND BATTERY MANUAL FOR MORE
INFORMATION.
4.3.3 Storage
Storing the battery for more than 30 days:
Remove the battery from the device.
�
Storage the device in a location where the temperature is
�
between 7 ̊ C et 40 ̊ C (45 and 104 ºF).
4.4
Motor
1 kW DC brushless electric motor.
5
Additional information
5.1
Error codes
Error codes are generated to identify the cause of the stoppage -
the LEDs flash repeatedly. Here are the most common codes:
ONCE
A
NORMAL
CHARGING
Descriptions
LED code
Battery connection
3
issue
Surge protection
4
Low-voltage protection
5
5.2 Disposing of the battery
THE DEVICE'S BATTERY CONTAINS LITHIUM-ION WHICH IS A TOXIC
SUBSTANCE.
ALL TOXIC MATERIALS MUST BE DISPOSED OF
ACCORDANCE
CONTAMINATING
DISPOSING OF A DAMAGED OR END-OF-LIFE LITHIUM-
ION
BATTERY,
DISPOSAL FACILITY FOR MORE INFORMATION AND THE
APPROPRIATE GUIDELINES. TAKE THE BATTERIES TO THE
LOCAL
AUTHORIZED TO DISPOSE OF LITHIUM-ION BATTERIES. IF
THE BATTERY IS CRACKED, EVEN IN THE ABSENCE OF A
LEAK. YOU MUST NOT CHARGE OR USE IT. YOU SHOULD
REMOVE IT AND REPLACE IT WITH A NEW BATTERY. DO
NOT TRY TO REPAIR IT!
This avoids injuries and risks of fire, explosion or electric shock or
contaminating the environment:
Cover the battery's terminals using resistant adhesive tape.
�
�
Never try to remove or destroy any battery component.
Do NOT open the battery.
�
Should a leak occur, the electrolyte substances released are
�
corrosive and toxic.
AVOID this solution coming into contact with your eyes or skin
●
and do not swallow it.
�
AVOID disposing of this type of battery with your household
waste.
�
AVOID burning them.
AVOID taking then to a landfill site or any municipal solid
�
waste facilities.
Take them to an approved recycling or landfill center.
�
5.3 Spare parts
Spare parts are available from your distributor or by contacting us
directly. Please refer to the exploded view in the APPENDIX at the
end of this manual to identify the part numbers.
Definitions
No communication between the
battery and the control card.Or loss
of communication during the
current phase.
The current process exceeds the
maximum admissible load.
The battery charge is
minimum(Recharge the battery).
WITH
DIRECTIVES
TO
THE
ENVIRONMENT.
CONTACT
YOUR
LOCAL
RECYCLING
AND
LANDFILL
EN
IN
AVOID
BEFORE
WASTE
CENTER
8
Advertenties
Inhoudsopgave
