Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
PITCHING INSTRUCTIONS
2. 'Using the beading' : If your vehicle has awning channel on you can use the beading sewn
into the top edge of the tunnel. Our tunnel comes with two different sizes, 6mm and 4mm
beading. This is to ensure that the beading can be used with the vast majority of different
channels. Use the appropriate beading for your channel remembering that the closer the fit
the more rain resistant it is. Slide the tunnel to the desired location on your vehicle.
3. 'Using your Wind Out Canopy' : If you have a roll out canopy/awning on your vehicle you
can use this to connect to. First unwind your canopy from your van. You will find that there is
a standard awning channel along the front of the canopy. Slide one of the awning beading
along the top edge of the tunnel into this channel. Once the tunnel is in the desired location,
wind your canopy back away and this will pull the tunnel into position against the side of your
vehicle.
4. 'Using the pole': You can also use the included pole and your suction hooks(not supplied)
to attach the tunnel to the side of your van. First slide the pole into the sleeve along the top
edge of the tunnel. Then using your suction hooks attach the hooks to the pole and sucker
them to your vehicle. You may find that the pole in the sleeve can be placed into the guttering
of your vehicle and clipped (clips not supplied) into place. Either way is acceptable.
• Once you have connected your tunnel to your vehicle you can tension the tunnel and peg
the awning.
• First peg the two bottom rear corners of the tunnel just underneath your vehicle pulling the
tunnel against the side of your vehicle.
• Next move the awning away from your vehicle until the roof of the tunnel becomes tensioned.
• Once the tunnel roof is tensioned peg the rest of the tunnel.
• Once pegged the excess material can be held in place by adjusting the straps on
the corners of the tunnel.
3
Pumping
• You are ready to inflate your awning.
• Before you inflate your awning make sure you have read and understood the pump and
inflation section of these instructions. You must follow these instructions to ensure proper
inflation of your awning.
• Inflate your awning using the pump supplied ensuring the safety pressure valve is
connected to the pump at all times.
• Pump each air tube(s) in turn, until all have been pumped up and sprung into place.
2
3
6
Advertenties
Hoofdstukken
Inhoudsopgave
