Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Operating Instructions
GB
PROBLEM
CAUSE
The unit fails to start
Power supply failure
up
Water-full and its icon lighting
Ambient temperature too low or low high
The room temperature is lower than the set temperature in
cooling mode or higher temperature in heating mode
Bad cooling eects
There is direct sunlight
The doors and windows are open, the room is crowded or there
are other heat sources
Dirty lter
Air inlet or air outlet clogged
High noise level
The unit is being placed at uneven surface.
The compressor does
Initiation of overheat protection
not work
The remote control
Too long distance
does not work
The remote control didn't aim at signal receptor on unit.
The batteries have no electricity
I you are having trouble with your dehumidifer, please reer to below trouble shooting. I nothing o the below
works, please contact your retailer or servicing o your Air Conditioner.
Error Codes
CH01
Room temperature sensor failure
CH02
Tube temperature sensor failure
E4
Anti-freeze protection
FL
Water tank in chassis is full
18
REMEDY
Connect the unit to a live socket and turn it on
Drain the water stored in the unit.
It is recommended to use this unit between 8-35
Change the set temperature
Close the window curtain
Close the door and window, remove other heat sources
Clean or replace the lter mesh
Remove the obstruction
ut the unit at a at and rm place (may reduce noise)
Wait until the temperature decrease, the unit will re-start automatically
Bring the remote control close to the air-conditioner and ensure airs at
signa receptor on unit.
Replace the batteries
Check the room temperature sensor and related circuits
Check the tube temperature sensor and related circuits
Restore the functions automatically once anti-freeze protection
is over.
Drain the condensate and re-start the unit
Advertenties
Inhoudsopgave
