Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
FUNCTION OF THE OPERATION MODES AND INSTALLATION DESCRIPTIONS
Water drainage instruction
Empty the water tank
Unscrew the drain cover and remove the
water stopper. Empty the water tank and
reattache the water stopper and drain
cover.
Notes:
• Move the unit carefully to avoid leakage.
• Tilt the unit slightly backwards when
draining.
• Block the drain hole as soon as possible
before the tray is full if it cannot hold all
water in the unit to prevent the water
leakage and wet the oor or carpet.
• Water stopper and drain cover must be
tightly installed, to avoid new conden-
sate to wet the oor or carpet when the
unit re-starts working.
Connecting a water hose for continu-
ous drainage
Unscrew the drain cover and remove the
water stopper. Attach a 13 mm water
hose to the pipe on the unit. Lead the
other end of the water hose to a drain.
Make sure that the water can be drained
downwards.
Notes:
• Drain hose must be installed when
there's no water in the tray.
• It is suggested that not to use con-
tinuous drainage when unit is in COOL
mode, to ensure enough water recycle
in the unit to enhance the system cool-
ing eects.
• Put the drain hose in an inaccessible
place, not higher than drainage hole
and keep drain hose straight without
any exure.
• Keep the drain cover and its stopper
properly when continuous drainage is
adopted.
The air lter
The air lter prevents dust and dirt from
entering the machine, prolonging its life
expectancy. It is important the lter is cle-
aned regularly. otherwise the unit may be
seriously damaged. Therefore, clean the
lters at least once every two weeks.
Filter cleaning
1. Remove the lter.
2. Wash it with warm water and a mild
cleansing agent. Alternatively the lter
may be vacuum cleaned.
3. Let the lter dry and put it back.
Filter installation
Aim the end of the lter toward slot then
push lter gently into slot.
Notes:
• Be sure to install the lter to side panel
then for the lter to back panel.
• Install the lter with opposite direction
of removal.
• Install the lter into place gently to
avoid any damage to lter.
It is very important that the lter
is cleaned regularly; otherwise
the air conditioner might lose
capacity and even be seriously
damaged.
Storage instructions
Remote Control Storage
1. Insert remote controller into built-in
compartment in left side of unit.
2. Press the lower part of built-in compart-
ment gently to open it and take out
remote controller.
End of Season Storage
1. Screw o the drain cover and pull out
the stopper to drain condensate water
completely.
2. Keep unit running in fan mode for half
day to dry inside of unit completely to
prevent from going moldy.
3. Turn o the unit, pull out plug then
wrap the power cord around the wi-
re-winding pillar, insert the plug into
Operating Instructions
the universal xing hole at the back pa-
nel of the unit, install the water stopper
and drain cover.
4. Remove the heat exhaust hose assem-
bly, clean and keep it properly.
Notes:
• Hold the exhaust hose assembly with
both hands when removal.
• Push the fasteners aside on exhaust air
outlet using your thumbs, then pull out
exhaust hose assembly.
5. Pack the air-conditioner properly with
soft plastic bag and put it in dry place
with appropriate dust-proof measures,
and keep the unit away from children.
6. Take out the batteries from the remote
control and keep it properly.
Note:
• Assure the unit is stored in a dry place.
• All accessories of the unit shall be pro-
tected together properly.
Maintenance
Clean the condensor with Wood's cleaning
detergent. Read more about how to clean
your unit at woods.se Clean the unit with
a soft moist cloth. Do not use solvents or
strong cleaners as this might damage the
surface of the unit.
Service
If the Air Conditioner requires servicing,
you must rst contact your local retailer.
Proof of purchase is required for all war-
ranty claims.
GB
17
Advertenties
Inhoudsopgave
