Advertenties
Beschikbare talen
Beschikbare talen
EN
Description of how the light works without the remote control unit
If the light is switched on via the main switch / wall switch, the unit provides the
lighting scenario which was last set using the remote control unit (memory effect).
Attention! If the light was last switched off using the remote control unit, it cannot
be switched on again via the wall switch due to the memory effect.
Description of how the light works with the remote control unit
The enclosed remote control unit can be used universally for all lights of this type.
This also means that several lights can be controlled with the same remote control
unit.
The synchronous Controlling of several lights is not intended.
Operation of the remote control
1. ON/OFF: The light is switched on/off completely.
After being switched on again it adjusts to 100% brightness. All previous settings are
reset.
2. Night light: The night light is switched on. The main light slowly fades if it was
switched on previously.
3 & 4. Brightness regulator: The adjustment takes place in stages. By pressing for a
short period, it is possible to control the individual stages. Pressing the button
permanently results in the maximum or minimum brightness being reached.
Attention! If a mixed shade has been set via buttons 5 and/or 6, this setting may be
lost when adjusting the brightness.
5 & 6. White: Colour setting - cold white
Warm: Colour setting - warm white
The adjustment takes place in stages. By pressing for a short period, it is possible to
control the individual stages. Pressing the button permanently results in the wärmest
or coldest colour setting being reached.
7. Mode: Cyclical modes switch
Here, the '100% brightness - off - night light' functions are interconnected and run in
sequence.
Advertenties
