Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
Walk test
1
2
3
The walk test is used to check that the sensor function of
the motion switch works properly at the desired installa-
tion location.
To do so, apply the following settings:
• Turn the setting screw for the time setting (time)
to
2
the "Test" position.
• Turn the meter setting screw
to the "+" position
1
4
110°
180°
• The "twilight threshold" (Lux) function is hereby
inactive
3
Begin the walk test from outside the probable coverage
area and cross the coverage aria again and again
until
4
the motion switch switches.
Start
Start
End
End
The connected consumer is switched on. Wait until the con-
sumer turns off again and repeat the walk test until satis-
fied with the results.
270°
Start End
71
Advertenties
Inhoudsopgave
