Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Electrical connection
Variant 2:
➤ Press the spray paint out of the inner frame of the door (fig. k, page 16).
➤ Install the door.
➤ Insert the hose of the vent into the integrated vent opening of the service door
and the cassette tank (fig. k, page 16).
5.8
Installation of the tank flap
For the Saneo BW and Saneo CW models, mount a tank flap for the integrated water
tank.
➤ Using the template (fig. 3 1, page 4) create an opening in the outer wall.
➤ Seal the tank flap water tight (for example, with butyl rubber).
➤ Put the tank flap on the tank.
➤ Tightly fasten the tank flap with four C4x25 countersunk screws (not included).
➤ Slide the O-ring onto the inner tube of the tank flap (fig. n, page 18):
– A: Position of the O-ring with a wall thickness of 30 mm – 50 mm
– B: Position of the O-ring with a wall thickness of 20.5 mm – 30 mm
➤ Grease the O-ring. This makes it easier for the filler neck to be connected with the
upper part of the tank.
6
Electrical connection
!
WARNING!
The electrical system must be wired by qualified personnel.
A
NOTICE!
•
Do not connect the toilet to the voltage supply directly in parallel
with other power-consuming devices.
•
Do not connect the control of the toilet to a pressurised water pump.
•
The rated capacity of an external water pump must not exceed
100 W.
I
NOTE
•
The external water pump is not included in the scope of delivery.
•
A pre-fuse is not necessary, because the toilet is internally fused.
30
Saneo B, Saneo C
EN
Advertenties
Hoofdstukken
Inhoudsopgave
