Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installation
• Read this manual thoroughly and carefully be-
fore installation and operation.
• Ensure the machine is placed in a dry area and
that the surface has sufficient strength to sup-
port the appliance. Also ensure that there are
Transportation
• Do not move the machine while it is under op-
eration. Unplug the machine when moving the
machine.
Operation
Note: For safety reason, the machine can only start to operate with the jug (9) installed properly on the
motor base (6) and the protective over (12) is closed properly.
• Check if the machine is at the STANDBY mode.
• Unplug the machine and open the protective
cover (12), take out the jug (9) from the motor
base (6).
• Pour all the ingredients into the jug (9) and
close it with the jug lid (10) and place the cover
cap (11) correctly in place.
• Place the whole jug (9) onto the motor base (6)
& close the protective cover (12).
• Connect the power plug to a suitable electrical
power supply socket.
• Press the power switch (1) once to enter
STANDBY mode.
Then, press the power switch (1) again to switch
ON the machine and 20 (Note: Default speed is
20) will be shown on the digital control display
(5) or select a suitable speed by pressing the
Speed selected
Speed control button (2)
Pulse function (4)
Low speed ( )
Medium (
) and high (
speed
no obstructions nearby during operation of the
appliance.
• Ensure that the electrical power supply corre-
sponds with the rating label on the machine.
CAUTION! Never bypass any safety micro switch.
• Always remove the jug (9) when moving.
• Lift only at the motor base (6) when moving.
desired speed control button (2):
then be shown on the digital control display (5)
correspondingly.
• Select the time for operation (30s / 45s / 90s) by
pressing the timer button (3). Remaining time
will be shown on the digital control display (5).
Once the set time is elapsed, the machine will
stop operation and go to STANDBY mode.
• After use, always press the power switch (1) to
STANDNY mode and disconnect the plug from
the electrical socket.
Note: The digital control panel has 2 brightness
in blue colour. When you press, it will light up
brighter (dark blue). Otherwise, it will remain in
dimmer mode (light blue).
Description
For mixing liquids
)
For mixing liquids and solid ingredients
For ice crushing or short, power impulse movements.
Note: Use the pulse function for 1 ~ 2 seconds each
time. Repeated about several times if necessary.
/
/
will
EN
7
Advertenties
Inhoudsopgave
