Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
11. Mode button
Press the button to select BT/USB/SD function. Press for
2 seconds to turn the mediaplayer On or Off.
12. Play button
For switching between play and pause.
13. Folder button
Press this button to open the folder map of USB or SD-
card.
14. Repeat button
Press key for repeating of single track or all tracks.
15. Forward - Backward button
For title selection (short actuation) and increase or
decrease volume (long actuation).
16. SD port
Connect your SD/MMC devices to this slot to play music with MP3 or WMA format.
17. USB port
Connect your USB devices to this slot to play music with MP3 or WMA format.
18. MP3 Level
Adjust the level of media player.
CONNECT BT-DEVICE
1.
2.
3.
If password is required, you can enter "0000".
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
TROUBLESHOOTING
One certain method of determining if a speaker is faulty is to substitute a speaker that is known to work correctly for the
suspected problem speaker. If the "normally correct speaker" is experiencing the same difficulties or problems as the suspected
problem speaker, use the information below to isolate the problem.
Problem
Possible cause
No output
Cables
Intermittent
Poor connections
Constant noise,
Faulty electronic
buzzing and/or
humming
Poor low-
Improper polarity
frequency output
Set the search function on of the BT device you want to play the music. See the operating
instructions for that device..
Press the "MODE" button and activate BT-function of media player.
Find on your BT-device "VONYX" and make the connection
Action
Reseat all connectors
Substitute known good cables
Check solder joins
Inspect cable for damage
Inspect wire or connector for stray strand that may short
While it is possible for a faulty speaker to exhibit intermittent
output, it's more likely that an output cable/connector is the
problem. Check the soldering on your connectors.
Any constant noise originates in the amplifier, mixer, signal
processing, source device in the signal devices, or line-level
wiring. Check and correct system grounding as required. Chain
check for noisy sources or electronic components. Check wiring
for shielding.
When two speakers in close proximity to each other are
connected out-of-polarity, they can partially cancel each other out,
especially at low frequencies. Check your speaker cables to be
sure they are all identically wired and connected. Check the
balanced line signal cables to be sure they are all correctly wired.
5
Advertenties
Inhoudsopgave
