Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROLS AND CONNECTIONS
1.
Microphone Inputs
XLR and 6.3mm ¼" input jack for connecting a microphone.
2.
Line Inputs
XLR and RCA jack input for connecting audio units with line level
output (e.g. mixer, CD player)
3.
Line Outputs
XLR and 6.3mm ¼" output jack for connecting an extra active
speaker or audio unit with line level input.
4.
Microphone Level
Adjust the signal level of microphone.
5.
Line Level
Adjust the signal level of line input.
6.
Master Volume
Adjust the overall output level of the portable sound set.
7.
Treble
Adjust high tone control.
8.
Bass
Adjust low tone control.
9.
Clip Indicator
Indicator lights up when signal level is too high. When the LED
light up continually you must reduce the volume to protect the
speaker.
10. Power Indicator
Indicator lights up when power turned on.
4
Noted: Passive speaker output connector,
minimum load 8 Ohm!
Advertenties
Inhoudsopgave
