Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Optelec
5. Charging the battery
5.1. Charging the Traveller HD
To charge the Traveller HD, connect the power supply to the 12V DC IN jack
located on the left side of the unit. Plug the other end of the power supply into
a power outlet. The LED indicator next to the 12V DC IN jack will glow
orange continuously while the Traveller HD is charging. Once the unit is fully
charged, the LED indicator will turn green. If the LED indicator flashes, there
is a charging problem. In this case, disconnect the power supply and try
again.
Charging the Traveller HD takes approximately 6 hours. A fully charged
Traveller HD can operate for an average time of 3 hours, depending on the
power settings. Please note that, for safety reasons, only the power supply
that was delivered with the Traveller HD can be used to charge the unit's
battery.
5.2. Battery warning
When the battery charge reaches below 5% of its total
capacity, the unit will issue a battery warning every minute by
displaying the battery-empty icon for 2 seconds. When this
occurs, make sure to charge your unit as soon as possible.
When the battery is empty, the unit automatically switches off.
If a unit does not switch on, please make sure it is charged.
English
Traveller HD
21
Advertenties
Inhoudsopgave
