Inhoudsopgave
Advertenties
en
Illustrations
The illustrations referred to in the text
are shown on the fold-out pages at the
end of these operating instructions.
Installation and connection
Assembling the vacuum
cleaner (Fig. 01)
You can assemble the vacuum cleaner in
2 different ways.
You can place the suction tube either
above or below the PowerUnit.
Take care to assemble the vacuum
cleaner exactly as shown in the dia-
gram.
The advantages of placing the
PowerUnit at the bottom of the va-
cuum cleaner are as follows:
- Secure self-standing function possible
(see "Use – Self-standing function for
short pauses in vacuuming")
- Ergonomic (reduced strain on the
wrist)
- Convenient cleaning of large surfaces
The advantages of placing the
PowerUnit at the top of the vacuum
cleaner are as follows:
– Convenient cleaning underneath fur-
niture
– PowerUnit can be removed quickly
Using the PowerUnit solo (Fig. 02)
The PowerUnit can be used on its own
without the suction tube and electro-
brush as a quick way of vacuuming up
crumbs and fluff in specific areas.
Tip: This configuration is particularly
suitable when using the three-piece ac-
cessory set (see "Using the supplied ac-
cessories").
74
Connecting the Comfort handle
(Fig. 03)
Depending on how you decide to con-
figure your vacuum cleaner, you can
connect the Comfort handle to either
the suction tube or the PowerUnit.
Push the Comfort handle down onto
the suction tube connector from
above until it audibly clicks into place
(left image detail).
Slide the Comfort handle along the
guide line on the dust container
handle and down onto the PowerUnit
connector from above until it audibly
clicks into place (right image detail).
Switch off the vacuum cleaner using
the On/Off switch on the front of the
Comfort handle if you want to separ-
ate the sections.
Press the release button and remove
the Comfort handle by pulling it up-
wards (Fig. 04).
Connecting the PowerUnit and the
suction tube (Fig. 05)
Depending on how you decide to con-
figure your vacuum cleaner, the suction
tube is located either above or below
the PowerUnit.
Slide the suction tube along the guide
line on the dust container handle and
down onto the PowerUnit connector
from above until it audibly clicks into
place (left image detail).
Push the PowerUnit connector into
the suction tube from above until it
audibly clicks into place (right image
detail).
Press the release catch to separate
the individual sections from each
other (Fig. 06).
Advertenties
Hoofdstukken
Inhoudsopgave
