Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Pica II
Load Label Roll in Standard Mode
NOTICE!
As for the electrostatic unloading the thin coating of the thermal printhead or other electronic parts can be damaged,
the label material should be antistatic.
The use of wrong materials can lead to printer malfunctions and the guarantee can expire.
K
J
I
H
G
F
•
Open the printer cover.
•
Open the printhead (K) by turning the red pressure lever (J) anticlockwise.
•
Remove the outside label mounting plate (A).
•
Load the label roll with inner winding onto the unwinding roll (B).
•
Attach again the label mounting plate (A).
•
Lead the label material below the return pulley (D) and the printhead (K).
Pay attention that the label runs through the photocell (E).
•
In order to move the printhead (K) down, turn the red pressure lever (J) in clockwise direction until it locks.
•
Adjust the adjusting ring (C) of the return pulley (D) to the width of material.
•
Close the printer cover.
Load Label Roll in Tear-off Mode
The printer is equipped by default with an integrated tear-off edge (not with option cutter or dispenser).
For an operation with tear-off edge (I) unscrew the two knurled knobs (F) and remove the front plate (G).
68
E
D
C
English
A
B
Advertenties
Hoofdstukken
Inhoudsopgave
