Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
V. 01 – 02/09/2019
Zero or Tare Function
To weigh different loads consecutively without removing loads from the scale.
Put the first load on the scale, get weight reading. Press the Z/T button to reset
the LCD reading to "0" before adding the next load. You can repeat this
operation.
Condition 1: ZERO function
When the total sum of all loads on scale ≤ 4 % of scales max. weight capacity.
(4 % = 200 g when capacity = 5 kg)
The LCD will show "----" or "0g" each time Z/T is pressed. "---" means the
weighing is not stable, please wait for a moment. "0g" and "ZERO" on the lower
left corner of the LCD mean "ZERO" function is active. Max. capacity remains
unchanged.
Condition 2: TARE function
When the total sum of all loads on scale > 4 % of scales max. weight capacity.
(4 % = 200 g when capacity = 5 kg)
The LCD will show "----" or "0g" each time Z/T is pressed. "----" means the
weighing is not stable, please wait for a moment. "0g" and "TARE" on the upper
left corner of the LCD mean "TARE" function is active. Max. capacity is reduced
by total weight of all loads.
Alarm Timer
1.
Press T-SET to enter the alarm mode.
2.
Set the digit with
3.
Press T-SET to confirm and go to the next digit.
4.
Press T-SET to confirm and to start the countdown.
Press any key to stop the countdown. Press T-SET to clear.
5.
When the timer counts down to "00:00", the alarm will beep 60 times. The
scale will automatically shut off.
Temperature Sensor
The temperature is automatically displayed in the upper right corner.
Switch-Off
The scale will automatically switch off after 2 minutes of non-use.
You can also switch off the scale by pressing the on-off button.
Error Indications
1.
Battery power running low.
2.
Overloaded. Remove excess weight.
VTBAL107
/
. Max. countdown is 99:59.
4
©Velleman nv
Advertenties
Inhoudsopgave
