Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ELECTRICAL
WARNING – THIS APPLIANCE MUST BE EARTHED
This heater must be used on an A.C. ~ supply only and the voltage marked on the heater must correspond to the supply voltage.
POSITIONING THE HEATER
Always ensure that the heater is stood on a firm, level base near to, but not directly underneath a suitable mains supply socket.
Ensure that curtains and furniture are not positioned close to the chosen position.
WARNING: Please ensure the minimum clearance dimensions indicated in Fig.1 are maintained.
ASSEMBLY
WARNING: The heater must only be operated with the feet securely fitted and in the upright position.
Never use the heater as a portable appliance without the feet securely fitted using the screws provided.
To assemble, lay the heater on its back and remove the two foot fixing screws see Fig.2. Assemble the feet by pressing them
firmly into the convector body as indicated in Fig.2, the foot should clip into position.
Secure using the foot fixing screw, Return the heater to the upright position,
The appliance is now ready for use.
USING THE HEATER
IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE PLACED ON THIS HEATER.
Before using the heater ensure that all warnings and instructions have been carefully read.
To activate the heater, after installation or assembly, simply plug it in.
Note: The element has been coated with a protective film which will burn off during the first few minutes of use, this may
cause a small amount of fuming. This is quite normal – the fumes are non-toxic and will quickly disappear.
We recommend that you open a window to ventilate the room when using the heater for the first time.
CONTROLS
All models are fitted with a heat selection switch and a thermostat control knob, see Fig 3. The Clima ML Turbo model has a
mains power indicating Neon lens and a boost fan.
Thermostat
The thermostat controls the heat output according to the room temperature.
This ensures that the heater will not produce heat unnecessarily when the room is warm.
To set the temperature you require, gradually turn the thermostat knob clockwise until the desired temperature is reached.
Allow some time between increments for the room temperature to stabilise.
Alternatively to heat a cold room quickly, turn the thermostat knob to the Max position. When the room has reached the
desired temperature, turn the thermostat knob anticlockwise until the thermostat clicks off. The heater will then automatically
maintain this room temperature.
The thermostat also has a frost protection setting marked '
This setting is useful in areas such as garages to prevent frost damage. If the thermostat is set to its minimum setting '
heater will cycle ON and OFF to maintain a temperature of approximately 5°C to help protect against frosty conditions.
20
Clima_Manual.indd 20
Clima_Manual.indd 20
FR
'.
DE
EN
NL
PL
SV
', the
7/05/21//18 16:09
7/05/21//18 16:09
Heat se
Depend
tion of
Mode
S
This ap
In addit
Safety
The hea
operate
Reconn
Tilt swi
The pro
in any d
If the h
Reconn
Note: T
is norm
A
Turbo f
The tur
This cir
The tur
Importa
Althoug
coloure
manufa
Alterna
You ma
This do
The hea
Advertenties
Inhoudsopgave
