battery and in the battery com-
partment before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Using the product for
the first time
Note: Please remove all packaging material from
the product.
Note: The product has three viewing sides. Left
side has 2x magnification mirror
and 5x magnification mirror
sides are the regular plane mirror.
Inserting / replacing batteries
Remove the battery cover
product and insert the batteries. Please note
the correct polarity, which is displayed in the
battery compartment
Close the battery cover
changing the batteries.
Installation
Align the stand base
facing the same direction (see Fig. C).
9
Insert the mirror holder
(see Fig. D).
10
Ensure the main mirror
are connected securely (see Fig. E).
10
Note: Small accessory such as make-up tools
or jewelry can be stored on the tray of stand
base
.
10
Use
Note: The primary function of the product is mirror
with normal, 2 x and 5 x magnification. It is NOT
16 GB/IE
on upper side
2
. Middle and right
1
on back side of
7
(see Fig. B).
12
after inserting /
7
and the mirror holder
10
into the stand base
9
and the stand base
3
intended to be used as table lamp for household
room illumination.
Hold the product and then press the ON / OFF
switch
up to the "I" position (see Fig. A).
8
Touch the brightness selection button
bottom of the main mirror
Press the brightness selection button
approx. 3 seconds to set the brightness of light.
Note: Mirror can be tilted up to 70° if neces-
sary (see Fig. F).
Touch the brightness selection button
bottom of the main mirror
after finish.
To save the battery, hold the product and press the
ON / OFF switch
8
Note: Five times magnification
5x
Note: Two times magnification
2x
Connecting with USB power
Use the USB cable to connect the micro-USB
inlet
and suitable USB power supply device.
11
Hold the product and then press the ON / OFF
switch
up to "I" position (see Fig. A).
8
Touch the brightness selection button
bottom of the main mirror
Note: USB power is just for direct power supply
but not for charging the batteries.
Note: Disconnect the USB cable from the
micro-USB inlet
11
in the battery compartment
Cleaning and care
Disconnect the USB connection before cleaning!
Never use liquids or detergents, as these will
damage the product.
Clean the product on the outside only with a
soft, dry cloth.
on the
6
to turn on the light.
3
for
6
on the
6
to turn off the light
3
down to the "0" position.
on the
6
to turn on the light.
3
if the batteries are inserted
.
12