Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
17. Troubleshooting and Service
One LED flashes
rapidly and water
remains cold
All LEDs flash rap-
idly and water gets
warm
All LEDs flash
rapidly and water
remains cold
LED turns off shortly
after keypress
LED flashes after
keypress
No LED lights
If the connection cable is damaged, it must be replaced with an original spare cable from the
manufacturer by an authorised technician in order to avoid any hazards.
If you cannot rectify the fault with the aid of the troubleshooting table, please contact custo-
mer service.
If you cannot rectify the fault with the aid of this table, please contact customer service.
CLAGE GmbH
After-Sales Service
Pirolweg 1 – 5
21337 Lüneburg
Germany
Phone: +49 4131 8901-40
Email: service@clage.de
We can either give you the name and address of an authorised customer service company or
repair the heater ourselves. In the latter case, please send in the heater (at your cost and risk)
with details of the problem and a copy of the sales invoice.
Defective temperature sen-
sor
Defective heating element
Defective control panel
cable
Defective power unit
Keylock is active
Touch key was not touched
in centre
Touch key calibration active
LED Standby active
Replace temperature sensor (authorized techni-
cian)
Replace heating element (authorized techni-
cian)
Reposition control panel connector (authorized
technician)
Replace control panel (authorized technician)
Call customer service
Deactivate keylock ("How to use", 29)
Don't touch the touch key for approx. 3 seconds
(until LED lights up normally); for proper han-
dling, touch the touch key right in the centre
Check LED by touching the touchkey.
If still no LED lights up, check the fuses!
31
CLAGE
EN
Advertenties
Hoofdstukken
Inhoudsopgave
