Keep away the vacuum device from inflammable gases and
substances.
Danger !
Do not aspirate any combustible or explosive solvents, materials
soaked in solvents, explosive dusts, liquids such as petrol, oil, alcohol,
diluents or materials hotter then 60 °C (140 °F).
Otherwise there will be danger of fire and explosions!
Danger !
Use the socket of the vacuum device only for the purposes defined in
the instruction manual.
In case of any inappropriate usage, improper operation or repair, the
producer shall be exempt from liability.
Do not use any damaged extension lines.
If the connector line of the vacuum device has been damaged, it must
be replaced with a special connector line which is available from the
producer or their service.
Electric brushes: Do not allow the rotating brushes to get into contact
with the power connection line.
The voltage on the type sign must correspond to the grid voltage.
After every use and before any maintenance, switch off the vacuum
device and pull the power plug.
Pull on the plug only, not on the line.
Never plug or pull the power plug with wet hands.
The socket must be secured via a household fuse with a suitable
current rating.
Never open the vacuum device outdoors in rain or storm.
Danger !
Danger of suffocation
– Keep packaging material such as plastic bags away from children
Never stand or sit upon the vacuum device.
Particular caution is advised when ascending stairs. Pay attention to
standing safely.
Do not pull the suction hose and connection line over sharp edges, kink
it or shut it.
Always lay the suction hose and connection line so that nobody may trip
over them.
In case of any leakage of foam or liquid, immediately switch off the
vacuum device.
Always keep dry the inside of the lid.
Do not start the vacuum device including its accessories if:
– the vacuum device shows detectable damage (fissures/ cracks);
– the power connection line is defective or shows fissuring or ageing; or
– any invisible defect is suspected (after a fall).
– Do not allow the rotating brushes to get into contact with the power
connection line.
21